Calculating the amount of carburizing agent to add is a crucial practical step.
Core Calculation Formula
The core formula for calculating the amount of carburizing agent to add is as follows:
Carburizing Agent Added Amount (kg) = [(Target Carbon Content - Initial Carbon Content) × Iron/Steel Weight] / (Fixed Carbon Content × Absorption Rate)
To better understand, we can break it down into three calculation steps:
Calculation Steps
Step 1: Calculate the Required Amount of Carbon Added
Required Amount of Carbon Added (kg) = (Target Carbon Content % - Initial Carbon Content %) × Iron/Steel Weight (kg)
Target Carbon Content %: The carbon content you ultimately want to achieve.
Initial Carbon Content %: The original carbon content in the current molten iron/steel (needs to be determined through rapid testing or empirical estimation).
Iron/Steel Weight (kg): The total weight of the molten metal you are processing.
Step 2: Calculate the Effective Carbon Content of the Carbon Recarburizer
Effective Carbon Content (%) = Fixed Carbon Content % × Absorption Rate %
Fixed Carbon Content %: The carbon content stated on the carbon recarburizer product instructions, such as 98%, 99%, etc.
Absorption Rate %: This is an empirical value, depending on your production process (furnace type, addition method, etc.), usually between 70% and 95%. If you don't know, you can start by estimating from 80% and then adjust according to the actual situation.
Step 3: Calculate the Final Amount of Carbon Recarburizer Added
Carburizer Addition Amount (kg) = Required Increase in Carbon (kg) / Effective Carbon Content (%)
Important Notes and Influencing Factors
Absorption Rate is a Key Variable: This is the most uncertain factor in the calculation. It is affected by the following factors:
Furnace Type: Induction furnace added with the furnace (90%-95%) > Induction furnace added after melting and clearing (80%-90%) > Electric arc furnace added to the ladle (50%-80%). Timing and Method of Addition: Adding during tapping results in higher absorption than direct addition to the molten pool. Adding in batches is better than adding a large amount at once.
Temperature: Excessive temperature leads to severe burn-off of the recarburizer; insufficient temperature results in slow dissolution and diffusion. The optimal temperature is typically 1450-1550°C.
Stirring: Thorough stirring (such as electromagnetic stirring or steel flow impact) significantly improves absorption.
Recarburizer Itself: The particle size should be appropriate (usually 1-5mm or 5-10mm). Too fine a particle size leads to burn-off; too coarse a particle size makes dissolution difficult.
"Less is More" Principle: Excessive carbon content leads to substandard product performance and is very troublesome to handle (usually requiring dilution with scrap steel, which is costly). Therefore, in initial calculations or when unsure, add a slightly smaller amount, take a sample for testing, and then fine-tune.
Adjustments in Actual Production: Theoretical calculations are fundamental. In actual production, it is recommended to:
Record Data: After each addition, record the calculated amount, the actual amount added, and the final test results.
Reverse calculation of actual absorption rate: Based on the final result, deduce the actual absorption rate of the current production run to optimize the next calculation. The formula is: Actual absorption rate = [(Carbon content after carbonization - Carbon content before carbonization) × Weight of molten iron] / (Amount of carbonizer added × Fixed carbon)
Build your own experience database: Over time, you will obtain the absorption rate parameters most suitable for your factory's equipment and raw materials.
In summary, mastering this calculation formula is the first step. More importantly, you need to continuously accumulate experience through practice and refine the key parameter-the absorption rate-to make the calculation increasingly accurate.






